SiemensMania.cz

Bond · Posted: Sun Dec 03, 2006 1:02 pm Post subject:

sem si ho ted chtel zkusit nahrat akorat nemuzu najit takovou drobnost jako je kabel

D4X · Posted: Sun Dec 03, 2006 1:05 pm Post subject:

rekl byhc ze by stacilo kdyby sis naletoval konektor na prst a na palec u nohy zase USB pak kanbel nepotrebujes

ale tomaslanger psal ze mu nejde beta3 tak nevim jesli pujde tobe Think

dvojka sla pry v poho...

Bond · Posted: Sun Dec 03, 2006 1:45 pm Post subject:

hmm pokazdy se mi to sekne na tyhle chybe

Cant connect to Mobile with BootstrapLoader on Com 5

koukal sem i na navod o chybach ale nemuzu ji nijak opravit Crying or Very sad

tomaslanger · Posted: Sun Dec 03, 2006 2:38 pm Post subject:

To je stara znama zprava... ;-) Teda pro mne... Very Happy

Udelal sem to tak, jak sem psal anglicky pro toho polaka a jelo to... ;-) jenom mi nejde to zadavani PINu... Razz

suawek · Posted: Mon Dec 04, 2006 7:39 pm Post subject:

At last I've put SKEY into my phone, but still I cannot upload Your software. WinSwup shows an information I've written somewhere above (Cant connect to Mobile with BootstrapLoader). What the hell is going on? Smile

Is there any other way to upload this soft to my phone?

mart22 · Posted: Mon Dec 04, 2006 7:53 pm Post subject:

This isn´t problem with the file, but this is problem with connection or cable. What cable do you have(DCA 500/DCA 510/DCA 540)? Check the settings in Winswup(e.g. right COM port) and try to load the firmware in Service mode.(To get the phone to Service mode you can use Siemens X65 Formating Tools(EEpromForm)

pluto3 · Posted: Tue Dec 05, 2006 2:18 pm Post subject:

všechno tam nahážu winswup mi napíše Error on waiting for Stat-Data a pri pinu se to vypne tému tam mám standart

tomaslanger · Posted: Tue Dec 05, 2006 2:47 pm Post subject:

JJ, presne jako u pluta... Sad

tohle mi to dela taky... Sad

suawek · Posted: Tue Dec 05, 2006 4:21 pm Post subject:

I've got an original cable (COM) and two service cables (I use one of them to send patches to my phone). I tried to run my phone in Service Mode and then send software to my cell but it didn't work (I tried to do it with all the three cables I own and [probably] with all options that are possible to set up in WinSwup). What else can I do?