SiemensMania.cz

pbw2 · kolemjdoucí Joined: 20 Oct 2005 Posts: 3 1.00 SMM

Ok,first let me introduce myself .i'm johny.i write here because it is said to be the best siemens site in the world(i will agree if you help me )
Secondly i want to apologise for writing not in cesky ,the reason is simple i don't know this language .
My problem is following,recently i bought data cable for siemens dca-510,it is ended with com.I hoped that using this cable i would flash and patch my phone and laso take off simlock.in my phone siemens cx70 ,sw version 36,everything seems to be all rightb ,ubder acc i have plugged in:dca-510.however my computer doesn't see the cable.I think i have tried everything which was advised,i used simoco ,direct softkey editor or mpm,but there is no effect.How to solve tghis problem?i have also tried changing the speed and irq's of the com port in contriol panel but it doesn't work.Plizzzzz help.

Little_S · Posted: Sat Oct 22, 2005 4:11 pm Post subject: Re: dca-510/com very big problem

pbw2 · kolemjdoucí Joined: 20 Oct 2005 Posts: 3 1.00 SMM

i am not an expert ,but under acc category i have dca-510,and it is ended with com,i have one big plea ,could you translate my post into cesky language and ask about it on the main forum?tHx in advance

Little_S · Posted: Sat Oct 22, 2005 7:27 pm Post subject:

there's no need for that. many of our users speak english
try connecting mobile to SiMoCo with COM port 1 and/or 2 setting (i think you don't have more than 2 COM ports in your computer)
for windows COM ports setting you can try the highest speed, no more.
and about that DCA-510 thing - where is that cable from? there were few COM port cables that didn't have MAX323 chip(instead a pile of transistors,diodes,...)....i think they were not working correctly for all x55s (and naturally for x65s,x75s)

pbw2 · kolemjdoucí Joined: 20 Oct 2005 Posts: 3 1.00 SMM

ok,thx for help,i bought it on ebay,seller told me that maybe the cable is broken,so he will send me another.Hope to see you soon

kicco_79 · kolemjdoucí Joined: 23 Oct 2005 Posts: 27 1.00 SMM

Hello, I've a Siemens original DCA-510 usb cable. My problem is that:
I've an M75 and when the phone is connected to pc using DCA-510 it's all ok.. when i receive an sms or an incoming call, the phone seems to be disconnected and i must disconnect the cable and replug it (onto my usb port on pc side) and then it work. another problem is with modem driver (GPRS VIA COM) that don't work.. Any Idea?

lacibogi · Posted: Thu Jan 19, 2006 5:40 pm Post subject:

Problem with plugging could be because of not original cable. Sometimes I must do it too.